vaporx-logo

 VaporX XLT – Vape Vitals
Manufacturer VaporX
Tank Style Top-Feed Clearomizer
Method Direct Draw
Threading 601
Battery Style Li-Ion 650mAh
Warranty 30 Day
Replacement Tanks Coming Soon
MSRP 79.95
 

vx-xlt-bl-vapeworld-kb-main-image

Brief Overview

The VaporX XLT is an easy-to-use portable vaporizer that features a clear tank cartomizer for use with liquid concentrates. The XLT makes vaporization easy with its simple loading system, one-touch activation, and 6-click battery lock. The clear liquid tank also features an easy to view measuring scale to keep track of remaining materials.

See User Guides below for full usage information.

Using Your XLT

A: As with most pen vaporizers, the XLT is super easy to use. Refer to the full instructions located on the ‘User Guide’ tab, but here is a quick rundown on using the XLT:

Charge the XLT – This could take a few hours the first time, but subsequent charges should not take longer than 45-60 minutes.

Load the XLT – Loading the tank is easily done by removing the mouthpiece from the XLT connector, then filling the tank 3/4 full. Avoid letting the liquid flow into the center tube. After you replace the mouthpiece, make sure the wick is fully saturated by allowing it to sit for two minutes. Avoid ‘dry firing’ – press the power button for one second, which should create just enough heat to allow the liquid to fully saturate the wick, then use as normal.

Power up and draw – If the switch on the XLT is locked, unlock by pressing the button six times. This enables the power switch and the XLT is ready to use. Press the button and immediately begin using the XLT. Use until you have had your fill or then ten-second shut off turns the atomizer off.

A: The XLT heats up instantly. With a 650mAh Li-Ion battery, the XLT is ready to go when you are.
A: There are no temperature settings on the XLT. It goes from room temperature to its peak temperature in just one second.
A: First and foremost its vital that you use the cleanest and purest liquids you can find. The XLT was designed for use with liquids that vaporize cleanly and leave no particulate behind.

Varying your draw rate can effect vapor thickness, slowing your draw rate will create thicker vapors, and a quick draw rate will create slightly thinner vapors.

Since the XLT has only one temperature setting, its essentially foolproof. Press the button to begin vaporization and use until you have your fill or until the XLT shuts off automatically after 10 seconds.”

A: The XLTwas designed solely for liquids.

Do not put aromatic blends or solid concentrates that melt into the atomizer included with the the XLT.

A: The charger is USB only.
A: First and foremost its vital that you use the cleanest and purest liquids you can find. The XLT was designed for use with liquids that vaporize cleanly and leave no particulate behind.

Varying your draw rate can effect vapor thickness, slowing your draw rate will create thicker vapors, and a quick draw rate will create slightly thinner vapors.

Since the XLT has only one temperature setting, its essentially foolproof. Press the button, and use until you have your fill or until the XLT shuts off automatically after 10 seconds.

A: The atomizer coil is a nickel/aluminum-alloy(Nichrome). The wick is fiberglass, the tank is plastic and the body is made of steel.
A: Nichrome – Nichrome is a non-magnetic alloy of nickel, chromium, and often iron, usually used as a resistance wire in applications from atomizer coils to toasters and beyond.
A: Liquids love high temperatures, so you should not have an overheating issue!
A: 3/4 full should be fine, and do not allow liquid into the center tube.
A: Yes, after ten seconds of use, the XLT will power off.

There is also a safety on the power switch, clicking it six times turns off the power button, and repeating this turns the button back on. This is great if you have the XLT in your purse, or pocket, as it prevents it from going off accidentally and wasting your battery or worse.

As a general safety rule, do not leave the XLT unattended while powered on.

A: The XLT atomizers are rebuildable and also easily replaceable. You can replace them very easily by disconnecting them from the battery, and replace with a replacement tank.
A: There are no screens in the XLT.
A: The battery is a 650mAh battery with 601 threading.
A: The charger that comes with the XLT is USB/110v/240v. You may need an outlet adapter for non-North American locations.
A: When the XLT Battery is in need of a charge, the power button will flash 3 times when pressed.

At this time, remove the atomizer and screw the XLT Battery onto the XLT Wired USB Charger . The XLT Wired USB Charger can be connected to either a Wall Adapter or any compatible USB port.

A: According to VaporX, allow 3-4 hours charging time for the first 3-4 cycles. Then, it should only take about one hour to charge, depending on your charging source.

Cleaning & Maintenance

A: Any liquid that may have spilled out or collected on the body of your XLT can be removed with a warm damp cloth.

Within the crucible of your XLT tank, the coil works to clean itself by burning off any residue that comes in contact with it. We don’t recommend using any type of liquid cleaning agent in the XLT tank, as doing so could cause it to malfunction. If you are having issues with the atomizer, namely a distant change in aroma, please replace.

The mouthpiece can be soaked in isopropyl alcohol until the buildup dissolves. Do not clean the rubber or silicone o-rings with alcohol, as it could damage them. Remove o-ring with a non-sharp tool(toothpicks work well) then use warm soap and water to clean.

Atomizers do not last more than 4-5 weeks with normal use. Your experience will vary, replace as needed.

A: If you are having issues with the atomizer, namely a distant change in aroma, please replace. Atomizers will last more than 4-5 weeks with normal use. Your experience will vary.
Monitor and replace atomizer as needed. Check your vape each time you use it, it will tell you how often it needs to be cleaned.
A: Cleaning the atomizer is not recommended, replace as needed.

Make sure you don’t expose the atomizer or battery to any cleaning liquids whatsoever. If you need to clean the outside of the XLT, use a warm damp cloth. If the XLT gets wet in any way, allow to dry in the sun or a warm dry area until COMPLETELY DRY. Attempting to use the XLT if wet will cause serious damage to the unit.

A: The atomizer should be replaced as needed on the XLT; it is not rebuildable. Over time even the purest liquids will allow buildup to collect on the Atomizer coil; replace as needed.

Atomizers will last 4-5 weeks with normal use. Your experience will vary.

Ordering – Returns – Warranty

A: 30 Day
A: Not at this time.
A:

VaporX XLT 30 Day Warranty

Vapor Corp. is handling all of the warranty requests and service for the VaporX XLT.

  • vapor-corp.com/register

VaporX warrants our products to be free from defects in materials and workmanship for 30 Days from the date of purchase under proper use. Warranty excludes cartridges, misuse or abuse, and any accidental damages.

*IMPORTANT: WARRANTIES NON-TRANSFERABLE. ITEMS PURCHASED ONLINE FROM E-BAY, AMAZON, CRAIGSLIST, ETC. ARE CONSIDERED 2ND HAND AND WARRANTIES NULL AND VOID!

If you need more information about XLT’s Warranty, please contact us

A: Your warranty period begins with your date of purchase. Contact Vape World for more information about warranty registration. If you need proof of purchase information for your Vape World purchased XLT, please contact us.

If you have any other questions about the XLT vaporizer, please contact us!

Product Dimensions 5.3in x .5in x .5in (13.5cm x 2.27cm x 2.27cm)
Package Dimensions 7in x 4.5in x 3in (17.8cm x 11.4cm x 7.6cm)
Product Weight .09bs (.04kg)
Package Weight .55lbs (.22kg)
Vapor Path Steel, Plastic
Tank Material Plastic
Tank Capacity 1.3ml
Charging Options USB/110v/240v
Battery Capacity 650mAh
Resistance TBD Ohm
Voltage TBD
Auto-Off? Yes, 10 second.
Safety Power Switch Yes, 6-Click
Heating Element Nickel/Aluminum-Alloy coil
Warm-Up Time ~1 Seconds
Country of Manufacture China
Warranty 30 Days

Included with Purchase:

  • VaporX XLT
    – Lithium-ion Battery (650 MAH) (601 Thread)
    – Clear Tank Cartomizer
  • USB Charger with Cable
  • User Manual
  • Wall Adapter for USB Charger

XLT User Guides

  • Coming Soon
*Adobe Reader or PDF viewer Required

Getting the Most Out of Your XLT

  • Never leave a XLT in a hot car. Ever.
  • Allowing the XLT to freeze can damage the atomizer. Avoid temperatures below 40 degrees.
  • Don’t allow liquid into the center tube when filling.

XLT Maintenance

Cleaning the XLT couldn’t be easier. Use the atomizer until the aroma suddenly changes, then replace or rebuild.

Atomizers will last 4-5 weeks with normal use; your experience will vary.

The inside of the mouthpiece will take on the most buildup, soak it in isopropyl alcohol and clean with a cotton swab if needed.

If any concentrate has made it onto the body of the XLT, wipe off with a warm damp cloth.

Need Assistance with your XLT?

Try these Solutions to common issues:

A: A few things could be causing this. Is the 3-click safety lock in place? Try clicking your XLT button six times and see if anything happens.

Are you getting any light at all from the button or the bottom? If not, make sure that its charged properly. This seems obvious, until you realize the power strip you were plugged into wasn’t turned on. Or…the USB port you were plugged into wasn’t actually a powered USB port. Or…there are many reasons to think your vaporizer is charging…when it isn’t. It happens all the time.

If you have charged it fully and unlocked the power button, and are still getting no vapors, remove the mouthpiece, press the button, and listen to see if there is any activity at all? if nothing happens, its possible your atomizer had expired.

Atomizers will last 4-5 weeks with normal use, however your experience may vary.

A: Make sure your XLT is fully charged, and the atomizer coil is screwed on fully and loaded properly (not overloaded). Check the connection between the battery and clearomizer for anything that could be blocking the connection.
A: The atomizers will last 4-5 weeks with normal use, although your experience will vary. Replace your atomizer when you feel it needs it. A change in aroma will be your first indicator the atomizer has died.

If these troubleshooting tips don’t work, please contact us.

vaporx-logo
Vape World carries replacement tanks for the XLT.

VaporX XLT 30 Day Warranty

Vapor Corp. is handling all of the warranty requests and service for the VaporX XLT.

  • vapor-corp.com/register

VaporX warrants our products to be free from defects in materials and workmanship for 30 Days from the date of purchase under proper use. Warranty excludes cartridges, misuse or abuse, and any accidental damages.

*IMPORTANT: WARRANTIES NON-TRANSFERABLE. ITEMS PURCHASED ONLINE FROM E-BAY, AMAZON, CRAIGSLIST, ETC. ARE CONSIDERED 2ND HAND AND WARRANTIES NULL AND VOID!

If you need more information about XLT’s Warranty, please contact us

Leave a Reply