quickdraw-logo

 QuickDraw L1 – Vape Vitals
Manufacturer QuickDraw
Tank Style Clearomizer
Method Direct Draw
Threading 510/eGo
Battery Style Li-Ion 390mAh
Warranty 1 Year
Replacement Tanks Coming Soon
MSRP 50.00
 

l1-vapeworld-kb-main-image

Brief Overview

The L1 by QuickDraw is a refined, compact vaporizer that vaporizes liquids evenly at the press of a button. Small enough to be ultra-portable, but powerful enough to produce large clouds of vapor, the L1 is the perfect device for your lifestyle.

See User Guides below for full usage information.

Using Your L1

A: As with most pen vaporizers, the L1 is super easy to use, and the L1 has a unique design that makes it more comfortable to hold. Refer to the full instructions located on the ‘User Guide’ tab, but here is a quick rundown on using the L1:

Charge the L1 – This could take a few hours the first time, but subsequent charges should not take longer than 45-60 minutes.

Load the L1 – Loading the tank is easily done by removing the mouthpiece from the L1 connector, then filling the tank 3/4 full. Avoid letting the liquid overflow into the center tube. After you replace the atomizer and then replace the tank to the L1, make sure the wick is fully saturated. Avoid ‘dry firing’ by pressing the power button for one second, which should create just enough heat to allow the liquid to fully saturate the wick, then use as normal.

Power up and draw – If the switch on the L1 is locked, unlock by pressing the button five times. This enables the power switch and the L1 is ready to use. Press the button and immediately begin drawing from the L1. Draw until you have had your fill, or the ten-second shut off turns the atomizer off.

A: The L1 heats up instantly. With a powerful 390mAh Li-Ion battery, the L1 heats up fast.
A: There are no temperature settings on the L1. It goes from room temperature to its peak temperature in just one second.
A: First and foremost its vital that you use the cleanest and purest liquids you can find. The L1 was designed for use with liquids that vaporize cleanly and leave no particulate behind.

Varying your draw rate can effect vapor thickness, slowing your draw rate will create thicker vapors, and a quick draw rate will create slightly thinner vapors.

Since the L1 has only one temperature setting, its essentially foolproof. Press the button, and draw until you have your fill or until the L1 shuts off automatically after 10 seconds.

A: The L1 was designed solely for liquids.

Do not put aromatic blends or solid concentrates that melt into the atomizer included with the the L1. QuickDraw makes other models for these substances, the X2 and the M1.

A: The charger is rated from 100v to 240v, but you might need an adapter for your outlet if outside North America. USB option is always available, negating the need for AC adapters, regardless of your location.
A: First and foremost its vital that you use the cleanest and purest liquids you can find. The L1 was designed for use with liquids that vaporize cleanly and leave no particulate behind.

Varying your draw rate can effect vapor thickness, slowing your draw rate will create thicker vapors, and a quick draw rate will create slightly thinner vapors.

Since the L1 has only one temperature setting, its essentially foolproof. Press the button, and draw until you have your fill or until the L1 shuts off automatically after 10 seconds.

A: The atomizer coil is nickel/aluminum-alloy, the wick is fiberglass, the crucible that surrounds the coil is ceramic, the body is made of steel.
A: Nichrome. Nichrome is a non-magnetic alloy of nickel, chromium, and often iron, usually used as a resistance wire in applications from atomizer coils to toasters and beyond.
A: Liquids and concentrates love high temperatures, so you should not have an overheating issue!
A: Is best to not fill the tank pas the level of the center tube. The L1 was designed to hold 1.6ml.
A: Yes, after ten seconds of use, the L1 will power off.

There is also a safety on the power switch, clicking it five times turns off the power button, and repeating this turns the button back on. This is great if you have the L1 in your purse, or pocket, as it prevents it from going off accidentally and wasting your battery or worse.

As a general safety rule, do not leave the L1 unattended while powered on.

A: There are no screens in the L1.
A: The battery is a 390mAh barrel 510/eGo ‘style’ battery. It has 510, and eGo threads.
A: The L1 comes with an AC adapter/USB plug, rated from 100v to 240v. The USB plug can be used by itself in a powered USB port anywhere in the world, but if you are charging your L1 outside of North America with the included AC adapter an outlet/plug adapter might be needed.
A: When the L1 Battery is in need of a charge, the power button will flash 3 times when pressed.

At this time, connect the L1 Battery to the L1 Wired USB Charger (at the base of the L1 Battery). The L1 Wired USB Charger can be connected to either the Wall Adapter or any compatible USB port. A red LED light will illuminate at the base of the battery to indicate that a charge is being administered.

Once the red LED light turns green, the L1 Battery has been fully charged.

A: According to QuickDraw, allow 3-4 hours charging time for the first 3-4 cycles. Then, it should only take about one hour to charge, depending on your charging source.

Cleaning & Maintenance

A: Any liquid that may have spilled out or collected on the body of your L1 can be removed with a warm damp cloth.

Within the crucible of your L1 tank, the coil works to clean itself by burning off any residue that comes in contact with it. We don’t recommend using any type of liquid cleaning agent in the L1 tank, as doing so could cause it to malfunction. If you are having issues with the atomizer, namely a distinct taste change, please replace.

The mouthpiece can be soaked in isopropyl alcohol until the buildup dissolves. Do not clean the rubber or silicone o-rings with alcohol, as it could damage the rubber. Remove o-ring with a non-sharp tool(toothpicks work well) then use warm soap and water to clean.

Atomizers do not last more than 4-5 weeks with normal use. Your experience will vary.

A: If you are having issues with the atomizer, namely a distinct taste change, please replace. Atomizers do not last more than 4-5 weeks with normal use. Your experience will vary.
Monitor and replace atomizer as needed. Check your vape each time you use it, it will tell you how often it needs to be cleaned.
A: Cleaning the atomizer is not recommended, replace as needed.

Make sure you don’t expose the atomizer or battery to any cleaning liquids whatsoever. If you need to clean the outside of the L1, use a warm damp cloth. If the L1 gets wet in any way, allow to dry in the sun or a warm dry area until COMPLETELY DRY. Attempting to use the L1 if wet will cause serious damage to the unit.

A: The atomizer should be replaced as needed on the L1; it is not rebuildable. Over time even the purest liquids will allow buildup to collect on the Atomizer coil; replace as needed.

Atomizers will last 4-5 weeks with normal use. Your experience will vary.

Ordering – Returns – Warranty

A: 1 Year
A: Not at this time.
A: VapeWorld is handling all of the warranty requests and service for the L1. Full warranty and contact information for QuickDraw is available on the warranty tab.
A: Your warranty period begins with your date of purchase. Contact VapeWorld for more information about warranty registration. If you need proof of purchase information for your VapeWorld purchased L1, please contact us.

If you have any other questions about the L1 vaporizer, please contact us!

Product Dimensions 4.5in x .5in x .5in (12.7cm x 1.27cm x 1.27cm)
Package Dimensions 7in x 4in x 3in (17.7cm x 10.2cm x 7.6cm)
Product Weight .05lbs (.02kg)
Package Weight .8lbs (.36kg)
Vapor Path Steel, Plastic
Tank Material Plastic
Tank Capacity 1.6ml
Charging Options USB/110v/240v
Battery Capacity 390mAh
Resistance TBD Ohm
Voltage TBD
Auto-Off? Yes, 10 second.
Safety Power Switch Yes, 5-Click
Heating Element Nickel/Aluminum-Alloy coil
Warm-Up Time ~2 Seconds
Country of Manufacture China
Warranty 1 Year

Included with Purchase:

  • QuickDraw L1
    – Liquid Cartridge With Mouthpiece
    – Lithium-ion Battery
  • Liquid Filling Bottle
  • Charging Kit
    – USB Charger
    – Wall Adapter
  • User Manual

L1 User Guides

*Adobe Reader or PDF viewer Required

Getting the Most Out of Your L1

  • Drawing after the heater has cooled down will allow the air vents to stay free of blockage.
  • Never leave a L1 in a hot car. Ever.
  • Allowing the L1 to freeze can damage the atomizer. Avoid temperatures below 40 degrees.
  • Use caution with the included tool, as it could damage the atomizer coil if you aren’t careful.
  • Overloading more than one session’s worth of concentrate is a potential recipe for mess.

L1 Maintenance

Cleaning the L1 couldn’t be easier. Use the atomizer until the taste suddenly changes, then replace or rebuild.

Atomizers will last 4-5 weeks with normal use; your experience will vary.

The inside of the mouthpiece will take on the most buildup, soak it in isopropyl alcohol and clean with a cottonswab if needed.

If any concentrate has made it onto the body of the L1, wipe off with a warm damp cloth.

Need Assistance with your L1?

Try these Solutions to common issues:

A: A few things could be causing this. Is the 5-click safety lock in place? Try clicking your L1 button five times and see if anything happens.

Are you getting any light at all from the button? If not, make sure that its charged properly. This seems obvious, until you realize the power strip you were plugged into wasn’t turned on. Or…the USB port you were plugged into wasn’t actually a powered USB port. Or…there are many reasons to think your vaporizer is charging…when it isn’t. It happens all the time.

If you have charged it fully and unlocked the power button, and are still getting no vapors, remove the mouthpiece, press the button, and see if the atomizer is at least getting warm?

If you have no activity from a fully charged L1, its possible that your atomizer has died. Try that atomizer on the other L1 that came in the package, and see if it works. If not, we have replacement clearomizers available.

A: Make sure your L1 is fully charged, and the atomizer coil is fully seated and loaded properly(not overloaded). Check the connection between the battery and clearomizer.
A: The atomizers will last 4-5 weeks with normal use, although your experience will vary. Replace your atomizer when you feel it needs it. Taste will be your first indicator the atomizer has died.

If these troubleshooting tips don’t work, please contact us.

quickdraw-logoVapeWorld carries atomizers and clearomizers that are compatible with the threading on the L1.

QuickDraw L1 1-Year Warranty

Vape World is handling all of the warranty requests and service for the L1.

QuickDraw warrants our products to be free from defects in materials and workmanship for one (1) year from the date of purchase under proper use. Warranty excludes cartridges, misuse or abuse, and any accidental damages.

*IMPORTANT: WARRANTIES NON-TRANSFERABLE. ITEMS PURCHASED ONLINE FROM E-BAY, AMAZON, CRAIGSLIST, ETC. ARE CONSIDERED 2ND HAND AND WARRANTIES NULL AND VOID!

If you need more information about L1’s Warranty, please contact us

Leave a Reply